From 1687222e1b9e74c89cafbb5910e72d8ec7bfd40f Mon Sep 17 00:00:00 2001 From: =?UTF-8?q?J=C3=B6rg=20Frings-F=C3=BCrst?= Date: Wed, 31 Jul 2019 16:59:49 +0200 Subject: New upstream version 1.0.28 --- doc/sane-dc210.man | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-) (limited to 'doc/sane-dc210.man') diff --git a/doc/sane-dc210.man b/doc/sane-dc210.man index bc0db75..7d3ad65 100644 --- a/doc/sane-dc210.man +++ b/doc/sane-dc210.man @@ -14,15 +14,15 @@ connected. The device name is always "0". .SH CONFIGURATION The contents of the .I dc210.conf -specify the serial port and baud rate to use. The baud rate +specify the serial port and baud rate to use. The baud rate specifies the maximum rate to use while downloading pictures. (The camera is always initialized using 9600 baud, then switches to the higher rate). On my 90MHz Pentium, I usually have no problems downloading -at 115200 baud as long as the system is not excessively busy and +at 115200 baud as long as the system is not excessively busy and the "interrupt-unmask flag" is set in the IDE driver (hdparm \-u1). Supported baud rates are: 9600, 19200, 38400, 57600, and 115200. .PP -The dumpinquiry line causes some information about the camera to +The dumpinquiry line causes some information about the camera to be printed. .PP cmdrespause specifies how many usec (1,000,000ths of a) between @@ -30,7 +30,7 @@ writing the command and reading the result should be used. 125000 seems to be the lowest I could go reliably. .PP breakpause is the time in 1,000,000ths of a usec between sending the -"back to default" break sending commands. +"back to default" break sending commands. .PP Empty lines and lines starting with a hash mark (#) are ignored. A sample configuration file is shown below: @@ -81,7 +81,7 @@ to "/tmp/config:" would result in directories "tmp/config", ".", and .TP .B SANE_DEBUG_DC210 If the library was compiled with debugging support enabled, this -environment variable controls the debug level for this backend. +environment variable controls the debug level for this backend. A value of 128 requests maximally copious debug output; smaller levels reduce verbosity. @@ -101,7 +101,7 @@ Henning Meier-Geinitz. Known bugs/limitations are: ? .PP More general comments, suggestions, and inquiries about frontends -or SANE should go to the SANE Developers mailing list -(see http://www.sane\-project.org/mailing\-lists.html for details). +or SANE should go to the SANE Developers mailing list +(see http://www.sane\-project.org/mailing\-lists.html for details). You must be subscribed to the list, otherwise your mail won't be sent to the subscribers. -- cgit v1.2.3