From 1687222e1b9e74c89cafbb5910e72d8ec7bfd40f Mon Sep 17 00:00:00 2001 From: =?UTF-8?q?J=C3=B6rg=20Frings-F=C3=BCrst?= Date: Wed, 31 Jul 2019 16:59:49 +0200 Subject: New upstream version 1.0.28 --- doc/sane-umax.man | 24 ++++++++++++------------ 1 file changed, 12 insertions(+), 12 deletions(-) (limited to 'doc/sane-umax.man') diff --git a/doc/sane-umax.man b/doc/sane-umax.man index 7dd9382..41b4beb 100644 --- a/doc/sane-umax.man +++ b/doc/sane-umax.man @@ -20,12 +20,12 @@ parallel- and USB-scanners are not (and probably will never be) supported! .SH CONFIGURATION -The configuration file for this backend resides in +The configuration file for this backend resides in .IR @CONFIGDIR@/umax.conf . Its contents is a list of device names that correspond to UMAX and UMAX compatible scanners. Empty lines and lines starting with a hash mark (#) are ignored. A sample configuration file is -shown below: +shown below: .nf # this is a comment @@ -44,19 +44,19 @@ shown below: option calibration\-width\-offset \-1 option calibration\-bytes\-pixel \-1 option exposure\-time\-rgb\-bind \-1 - option invert\-shading\-data \-1 + option invert\-shading\-data \-1 option lamp\-control\-available 0 option gamma\-lsb\-padded 0 - /dev/sge -\ - #scsi Vendor Model Type Bus Channel ID LUN + /dev/sge +\ + #scsi Vendor Model Type Bus Channel ID LUN # The following scanner supports lamp control option lamp\-control\-available 1 - scsi UMAX * Scanner * * * * * -\ + scsi UMAX * Scanner * * * * * +\ # scanner on /dev/scanner does not support lamp control option lamp\-control\-available 0 - /dev/scanner + /dev/scanner .fi .TP @@ -194,7 +194,7 @@ command queueing you can try to set this value to 1. .PP The special device name must be a generic SCSI device or a symlink to such a device. To find out to which device your scanner is assigned and how you have to set the -permissions of that device, have a look at sane\-scsi. +permissions of that device, have a look at sane\-scsi. .SH SCSI ADAPTER TIPS @@ -203,7 +203,7 @@ well by Linux (I suggest not to use it), the PCI-SCSI-adapters that come with so Umax-scanners are not supported at all (as far as I know). On other platforms these SCSI-adapters are not supported. So you typically need to purchase another SCSI-adapter that is supported by your platform. See the relevant hardware FAQs and HOWTOs for your -platform for more information. +platform for more information. The UMAX-scanners do block the scsi-bus for a few seconds while scanning. It is not necessary to connect the scanner to its own SCSI-adapter. But if you need short @@ -240,7 +240,7 @@ SANE_DEBUG_UMAX values .ft CR .nf Number Remark -\ +\ 0 print important errors (printed each time) 1 print errors 2 print sense -- cgit v1.2.3