diff options
Diffstat (limited to 'doc/sane-sharp.man')
| -rw-r--r-- | doc/sane-sharp.man | 24 |
1 files changed, 12 insertions, 12 deletions
diff --git a/doc/sane-sharp.man b/doc/sane-sharp.man index 34ad8cb..b26ecb5 100644 --- a/doc/sane-sharp.man +++ b/doc/sane-sharp.man @@ -98,7 +98,7 @@ default selection. .TP .B \-\-custom\-gamma -Custom Gamma This option determines whether a builtin or a custom +Custom Gamma. This option determines whether a builtin or a custom gamma table is used. Possible settings are: .I yes (enables custom gamma tables) or @@ -197,7 +197,7 @@ This option is only available in scan mode .TP .B \-\-threshold-red -Sets the threshold for the red component of a pixel in +Sets the threshold for the red component of a pixel in lineart color scan mode. Possible values are 1..255. The default value is 128. This option is only available in scan mode color @@ -205,7 +205,7 @@ This option is only available in scan mode color .TP .B \-\-threshold-green -Sets the threshold for the green component of a pixel in +Sets the threshold for the green component of a pixel in lineart color scan mode. Possible values are 1..255. The default value is 128. This option is only available in scan mode color @@ -213,7 +213,7 @@ This option is only available in scan mode color .TP .B \-\-threshold-blue -Sets the threshold for the blue component of a pixel in +Sets the threshold for the blue component of a pixel in lineart color scan mode. Possible values are 1..255. The default value is 128. This option is only available in scan mode color @@ -321,11 +321,11 @@ stops. Stops of the carriage can be caused by the following reasons: .PP .RS -\- too much "traffic" on the SCSI bus +\- too much "traffic" on the SCSI bus, .br \- slow responses by the backend to the scanner, .br -\- a program which processes the data acquired by the backend too slow. +\- a program which processes the data acquired by the backend is too slow. .PP .RE Too much "traffic" on the SCSI bus: This happens for example, if hard disks @@ -409,12 +409,12 @@ backend. At present, the scanner must power off and on to stop this annoying behaviour. .RE -2. Threshold level does not work (only JX-610) +2. Threshold level does not work (only JX\-610) .PP -3. The maximum resolution is limited to 600 dpi(JX-610 supported -to 1200 dpi) resp. 400 dpi (JX-250) +3. The maximum resolution is limited to 600 dpi (JX\-610 supported +to 1200 dpi) resp. 400 dpi (JX\-250) .PP -4. If the JX250 is used with an ADF, the following situation can occur: After +4. If the JX\-250 is used with an ADF, the following situation can occur: After several scans, the scanner moves, after loading a new sheet of paper, the carriage to the idle position, and then back to the position used for ADF scans. This happens for @@ -436,8 +436,8 @@ tested. Kazuya Fukuda, Abel Deuring .SH CREDITS -The Sharp backend is based on the Canon backend written by Helmut Koeberle +The Sharp backend is based on the Canon backend written by Helmut Koeberle. .PP Parts of this man page are a plain copy of .BR sane\-mustek (5) -by David Mosberger-Tang, Andreas Czechanowski and Andreas Bolsch +by David Mosberger-Tang, Andreas Czechanowski and Andreas Bolsch. |